XEND — Transactional End

Opcode/Instruction Op/En 64/32bit Mode Support CPUID Feature Flag Description

0F 01 D5

XEND

A V/V RTM Specifies the end of an RTM code region.

Instruction Operand Encoding

Op/En Operand 1 Operand2 Operand3 Operand4
A NA NA NA NA

Description

The instruction marks the end of an RTM code region. If this corresponds to the outermost scope (that is, including this XEND instruction, the number of XBEGIN instructions is the same as number of XEND instructions), the logical processor will attempt to commit the logical processor state atomically. If the commit fails, the logical processor will rollback all architectural register and memory updates performed during the RTM execution. The logical processor will resume execution at the fallback address computed from the outermost XBEGIN instruction. The EAX register is updated to reflect RTM abort information.

XEND executed outside a transactional region will cause a #GP (General Protection Fault).

Operation

XEND

IF (RTM_ACTIVE = 0) THEN
    SIGNAL #GP
ELSE
    RTM_NEST_COUNT--
    IF (RTM_NEST_COUNT = 0) THEN
         Try to commit transaction
         IF fail to commit transactional execution
              THEN
                    GOTO RTM_ABORT_PROCESSING;
              ELSE (* commit success *)
                    RTM_ACTIVE ← 0
         FI;
    FI;
FI;
(* For any RTM abort condition encountered during RTM execution *)
RTM_ABORT_PROCESSING:
    Restore architectural register state
    Discard memory updates performed in transaction
    Update EAX with status
    RTM_NEST_COUNT ← 0
    RTM_ACTIVE ← 0
    IF 64-bit Mode
         THEN
              RIP ← fallbackRIP
         ELSE
              EIP ← fallbackEIP
    FI;
END

Flags Affected

None

Intel C/C++ Compiler Intrinsic Equivalent

XEND:

void _xend( void );

SIMD Floating-Point Exceptions

None

Other Exceptions

#UD

CPUID.(EAX=7, ECX=0):EBX.RTM[bit 11] = 0.

If LOCK or 66H or F2H or F3H prefix is used.

#GP(0) If RTM_ACTIVE = 0.